Canonical: https://ai.allesclinx.com/metricon/specific-gravity-calculator
Description: Calculate sample density and specific gravity from measured mass, volume and reference-fluid density.

[Back to Metricon](<https://ai.allesclinx.com/metricon>)

# Specific gravity calculator

Calculate sample density and specific gravity from a measured mass, volume and reference density.

## Inputs

Sample mass

g

Mass of the sample alone.

Sample volume

mL

Measured volume occupied by the sample.

Reference density

g/mL

Reference-fluid density at the relevant temperature.

Specific gravity  **—**

## Method & assumptions

Calculation formula `Density = mass ÷ volume · Specific gravity = density ÷ reference density`

### Sources, assumptions & review

User input  **Values you provide**

Check units, basis and local values before relying on the output.

Calculated  **Transparent model output**

Metricon applies the displayed formula to the inputs on this page.

Assumption  **Model boundary**

Scenario inputs and defaults are not measured facts unless you supplied them from a controlled source.

Review  **Human decision**

Compare the result with approved product directions, actual operating conditions and accountable judgement.

**Before using the result**

Specific gravity depends on temperature and the reference density used. Use appropriately calibrated mass and volume measurements for quality-control work.

## How it works

### Match sample and reference conditions

Use reference-fluid density at the relevant temperature for the sample comparison.

### Enter measured mass and volume

Use sample-only mass in grams, sample volume in mL and reference density in g/mL.

### Review density and the ratio

Check Sample density, Specific gravity and Relative to reference.

### Verify measurement quality

Use calibrated mass and volume measurements. Temperature and the chosen reference affect the comparison.

## Frequently asked questions

Does specific gravity have a unit?

No. It is sample density divided by reference density, with both densities on the same unit basis.

Should sample mass include the container?

No. Enter the sample alone; including the container would change the calculated density.

Can I always use reference density 1?

Use the reference-fluid density appropriate to the relevant temperature, rather than assuming a fixed value.
